An online lesson on using Autodesk Inventor was held

As a result of our President’s efforts in science and education, the industry’s growth rate is increasing. With the introduction of new information technologies in education, the need for learning through a digital education system increases. The effective use of these technologies leads to great achievements in various fields of science and practice. Developing students skills and abilities in future professional activities is the main task of training engineering personnols. In order to successfully implement these tasks, international cooperation activities are widely carried out at the Turkmen Agricultural Institute.

On May 23, 2024, an online training was organized between the Samarkand State University of Veterinary Medicine, Animal Husbandry and Biotechnology and the Turkmen Agricultural Institute by the head of the Department of Applied Mechanics, Guvanch Oraev, on the topic “Analysis of purse curvature in the Autodesk Inventor program.” Teachers and students from two universities took an active part in the training.

As part of the training course, solutions to the problems of the strength of materials course in the training of engineering specialists at our university were considered using the Autodesk Inventor software package. The use of the Autodesk Inventor program when solving problems of strength of materials will contribute to the formation of a unified understanding of the stressed, deformed state of the problem under consideration.

Thus, the training course was distinguished by its effectiveness, abundance of new information and efficiency and was of great importance in the introduction of a digital system into the country’s education system.

Shatlyk PYGAMOV,
Head of the Department of Agricultural Land Reclamation
Turkmen Agricultural Institute